Anyhoo . . . I had no real need to use it until someone gave me a big pile of carrots from their garden. Carrots are easy to can; however, they need to be pressure canned. So the time had come . . . do or hopefully not die. It turns out pressure canning isn't all that complicated or scary. It did it and I survived!
Like other canning methods, the jars have to be washed and
the lids have to be sterilized. This
prevents mold, fungus and other bacteria from feasting on your veggies.
When preparing the pressure canner you should follow the
directions included with your canner.
But a good rule of thumb is fill it with four inches of hot tap water
and put it on the stove over low heat, with the lid OFF, to get it heating up
for later on. It’s going to evaporate
some, but that’s okay.
The carrots have to be hot packed so they must be cooked for
5 minutes before packing them in the jars.
Simply bring the carrots to a boil and simmer for 5 minutes.
Next fill the jars, leaving 1-inch of headspace. Pack them fairly
tightly, but be sure to leave 1 inch of space at the TOP of the jar to allow
for expansion during heating. Use a
ladle or pyrex measuring cup to carefully fill each packed jar with water from
pot of boiling water that they were cooked in. The carrots should be covered
and there should still be 1 inch of airspace left in the top of each jar.
Put the lids on each jar and seal them by putting a ring on
and screwing it down snugly . . . but
not over tighten.
Using the jar tongs, put the jars on the rack in the
canner. By now the water level has
probably boiled down to 3 inches. If it
is lower than that, add more hot tap water to the canner. When all the jars
that the canner will hold are in, put on the lid and twist it into place, but
leave the weight off (or valve open, if you have that type of pressure canner).
Put the heat on high and let the steam escape through the
vent for 10 minutes to purge the airspace inside the canner.
After 10 minutes of venting, put the weight on and close any
openings to allow the pressure to build to 11 pounds.
Once the gauge hits 10 pounds, start your timer going - for
25 minutes. Adjust the heat, as needed,
to maintain 10 pounds of pressure. This
is for sea-level, the processing time will vary depending on your elevation.
After 25 minutes at 10 pounds, turn off the heat and let the canner cool down. After the pressure
drops to zero (usually, you can tell but the "click" sound of the
safety release vents opening, as well as but the gauge. Wait 3 more minutes, then open the vent or
remove the weight and allow the steam to escape.
Lift the jars out of the water and let them cool on a wooden
cutting board or a towel, without
touching or bumping them in a draft-free place (usually takes overnight). You can then remove the rings if you like. Once the jars
are cool, you can check that they are sealed verifying that the lid has been
sucked down. Just press in the center, gently, with your finger. If it pops up
and down (often making a popping sound), it is not sealed. If you put the jar
in the refrigerator right away, you can still use it. Some people replace the
lid and reprocess the jar, but that's a bit iffy. If you heat the contents
back up, re-jar them (with a new lid) and the full time in the canner, it's
usually ok.
That’s it. Easy
peasy.
No comments:
Post a Comment